![]() This is desired behavior, as it increases security and gives the firewall a performance boost. When the Wordfence firewall is optimized, the firewall loads before the WordPress environment loads. Advanced Options Delay IP and Country blocking until after WordPress and plugins have loaded The Real-Time IP Blocklist is a premium feature and has no effect when using the free version of Wordfence. The IP addresses are blocked by the firewall, so if your site has been set up with the firewall in “Extended Protection” mode then this traffic is blocked before WordPress begins loading. All of this happens automatically without you having to take any action. The premium Real-Time IP Blocklist feature prevents known attackers from accessing your site. This data is used to automatically generate a list of IP addresses that are currently involved in bad behavior. ![]() Wordfence monitors millions of attacks on WordPress sites every hour. If the firewall has been optimized, it will provide an extra layer of security and also improve firewall performance. The firewall “Protection Level” can be set to either “Basic WordPress Protection” or “Extended Protection”. In this mode, the firewall is functionally turned off and does not run any of its rules or analyze the request in any way. Use this mode to prevent false positives on your site. While in Learning Mode, these requests will be added to the firewall allowlist, excluding them from tripping the same rules once the firewall is enabled. Some requests contain data that may match patterns the firewall uses to detect attacks (such as an article about SQL injection that contains SQL code). In this mode, any requests that would normally be blocked by the firewall will be added to the firewall allowlist. In this mode, the firewall is actively blocking requests matching known attack patterns and is actively protecting your site from attackers. ![]() The modes of the Firewall are: Enabled and Protecting If you have recently cleaned your site from a hack, or if you are under attack, you can choose to set the Firewall status to “Enabled and Protecting” instantly after installing Wordfence. A false positive is when something gets blocked that you did not want to be blocked. The firewall will instead be learning how your system works in order to minimize “false positives”. During this time you will not have full protection from the firewall. When you first install Wordfence, the firewall will be in Learning mode for one week. The Wordfence firewall status can be either set to “Enabled and Protecting”, in “Learning Mode” or “Disabled”. In This Article Basic Options Advanced Options Brute Force Protection Rate Limiting Allowlisted URLs Basic Options Firewall Mode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |